Various things have to be in place for it to work. It is presumably configured for some local network address, with DHCP either on or off, NAT on or off and with an admin password set or not set. By default the DL-624 is on 192.168.x.x, NAT on, DHCP on, no admin password and an SSID set […]
Written on Wednesday, July 2nd, 2008 by majorsawyer :: 0 comments to this post
Various things have to be in place for it to work.
It is presumably configured for some local network address, with DHCP either on or off, NAT on or off and with an admin password set or not set.
By default the DL-624 is on 192.168.x.x, NAT on, DHCP on, no admin password and an SSID set to “default”.
With these settings, a typical PC is going to work, but those settings may not be what it is set to. You can reset it to factory default by holding the reset button for a suitably long time (20 works according to some googling).
Point you browser to 192.168.0.1 and see if the interface is there, username ‘admin’, password ‘password’ and fiddle with it a bit until it works. Make sure your computer(s) are set to get thier IP address automatically, or manually set them in the range 192.168.0.2 to 192.168.0.254.
Post Comments Here » 0 comments to this post
Check the Categories below for more on Router/internet?
More from Uncategorized(t) Categories
« my question is the mega millions rigged? :: Is it cheaper to rent a frame tent than to book a reception hall for a wedding? »
